SP10 accessories

SP10 accessories support PCBite SP10 handsfree probes in multimeter readings, logic analysis and powering or flashing boards, where a low-resistance contact matters most. Each SP10 has a dual pin header for 2.54 mm (0.100 in) jumper connectors, often called Dupont connectors, so two leads can leave the same probe, one to the instrument and one to a second probe or instrument. The ground cable accessories provide short Dupont leads of 5 cm (2 in) and 10 cm (4 in) for that second connection. They can make an SP10 the ground point for an SQ100 to SQ500 oscilloscope probe, or join two SP10 probes to connect two points on the board, for example to simulate a button press. The 2×4 Saleae wire harness plugs into the input header of a Saleae logic analyzer and splits into single Dupont leads, one for each SP10. The SP10 needle has a resistance below 0.02 Ω, and a bent or worn needle is replaced on its own, so the probe keeps the same low contact resistance. Cable holders in several colors make it easy to follow each lead from probe to instrument, and replacement glide pads let the probe holders move freely on the base plate again.